Preparation before use Before using the air conditioner, be sure to check and preset the following. Remote Controller presetting The remote controller is NOT presetting as Cooling Only Air Conditioner or Heat Pump by manufacturer. Each time after the remote controller replaces batteries or is energised, the arrowhead will flashes on the Front of “Heat” or “Cool” on LCD of the remote controller. User can preset the remote controller type depending on the air conditioner type you have purchased as follows: Press any button when the arrowhead flashes and pointing to “Heat, then Heat Pump is set Press any button when the arrowhead flashes and pointing to “Cool”, then Cooling Only is set. If you don’t press any button within 10 seconds, the remote controller is preset as Heat Pump automatically. Note: if the air conditioner you purchased is a Cooling only one, but you preset the remote controller as Heat Pump, it doesn’t bring any matter. But if the air conditioner you purchased is a Heat Pump one, and you preset the emote controller as Cooling Only, then you CAN NOT preset the Heating operation with the remote controller. Auto-restart Presetting: The appliance is preset as no auto-restart function by manufacture. If Auto-restart function is needed, follow the step below to activate this function: 1) Make sure the Air-con’s power is off: 2) Press down and hold the Emergency button (ON/OFF )on the indoor unit then electrify. 3) Keep pressing the Emergency button for over 10 seconds until three short beeps are heard. The Auto-restart function is then activated. To cancel the Auto-restart function, repeat above procedure until four short beeps are heard. Safety precautions Symbols in this Use and Care Manual are interpreted as shown below. Be sure not to do. The feature of the appliance, instead of a fault. Pay attention to such a situation. Be sure to follow this instruction. Grounding is essential. Warning: Incorrect handling could cause a serious hazard, such as death, serious injury, etc. Use correct power supply in accordance with the rating plate requirement Otherwise, serious faults or hazard may. occur or a tie maybe break out. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Keep the power supply circuit breaker or plug away from dirt. Connect the power supply cord to it firmly and correctly, lest an electric shock or a fire break out due to insufficient contact may occur. Do not use the power supply circuit breaker or pull off the plug to turn it off during operation. This may cause a fire due to a spark, etc. Do not tangle, pull or press the power supply cord, as this cold will be damaged and an electric shock or fire is probably caused by a broken power supply cord. It is harmful to your health if the cool air reaches you for a long period. It is advisable to allow the air flow to circulate to all the whole room. Never insert a stick or simile obstacle to the unit. When the fan rotates at high speed, this may cause an injury. Firstly turn off the appliance by remote controller before cutting off power supply if malfunction occurs. Do not repair the appliance by yourself…

Download SPLIT AIR-CONDITIONER OWNER’S MANUAL.Pdf