BEFORE drilling, make sure to check for wires or other items that may be damaged during rilling. Step 1: Prep the vehicle a) Remove the rear seat from vehicle. b) Remove factory seatbelt buckles and detach factory seatbelt anchors. Retain OEM mounting hardware, and this will be required later in the installation process. retain factory seatbelt buckles for vehicle resale. c) Remove any items from the trunk that may impede the installers ached to the roof of . not attempt to Hardware with this from getting in and out of the trunk easily. tt n drill through the liner or mount Ready Buckle !!! Some Chargers are equipped with a liner a the trunk. Remove this liner before Installatio liner in place. Step 2: Locate and mount Reinforcement Plate a) From the trunk, place Reinforcement Plate (Item position by aligning holes in the Reinforcement Plate contour of the underside of trunk and trunk dome b) With the Reinforcement Plate in position, stick a through the two welded nuts. Mark and drill two 12.7MM drill bit on your marks. Notes: Make sure the Reinforment Plate lays flat aga bottom decklid. 5) into with light. thin marker holes with a inst the Step 3: Locate and mount the Retractor Mounting Plate d a) Center the Retractor Mounting Plate (Item 6) on the deck lid. Mark on the decklid, the position of the Retractor Mounting Plate spacers. Cut hole in deck lid carpet (where holes were drilled in decklid), and place Retractor Mounting Plate spacers flush on the decklid steel…

Download Dodge Charger Ready Buckle Installation Manual.Pdf