CVT FLUID COOLER CLEANING PROCEDURE 1. Identify the CVT inlet and outlet fluid cooler hoses. 2. Position an oil pan under the inlet and outlet cooler hoses. 3. Disconnect the fluid cooler inlet and outlet rubber hoses from the steel cooler tubes. NOTE: Replace the cooler hoses if rubber material from the hose remains on the tube fitting. 4. Allow any CVT fluid that remains in the cooler hoses to drain into the oil pan.5. Insert the extension adapter hose of a can of Transmission Cooler Cleaner (Nissan P/N 999MP-AM006) into the cooler outlet hose. CAUTION: • Wear safety glasses and rubber gloves when spraying the Transmission Cooler Cleaner. • Spray Transmission Cooler Cleaner only with adequate ventilation. • Avoid contact with eyes and skin. • Do not breath vapors or spray mist. 6. Hold the hose and can as high as possible and spray Transmission Cooler Cleaner in a continuous stream into the cooler outlet hose until CVT fluid flows out of the cooler inlet hose for 5 seconds. 7. Insert the tip of an air gun into the end of the cooler outlet hose. 8. Wrap a shop rag around the air gun tip and of the cooler outlet hose. 9. Blow compressed air regulated to 5 – 9 kg/cm2 (70 – 130 psi) through the cooler outlet hose for 10 seconds to force out any remaining CVT fluid. 10. Repeat steps 5 through 9 three additional times. 11. Position an oil pan under the banjo bolts that connect the CVT fluid cooler steel lines to the transaxle. 12. Remove the banjo bolts. 13. Flush each steel line from thecooler side back toward the transaxle by spraying Transmission Cooler Cleaner in a continuous stream for 5 seconds…

Download 2008 Maxima CVT System.Pdf